Re: PE2950 BIOS upgrade without floppy drive
At this point, you have 3 options. #1 is to try the linux based update packages from within Xen, they should work properly. #2 is to use Repository Manager to create a bootable deployment media that...
View ArticleRe: Dell Poweredge R210 II not liking Tripplite Ps2 to USB adapter for KVM
you have a link to the model of triplite adapter you have?
View ArticleRe: PowerEdge 1855 GbE Passthrough
Yep, the mezzanine card/daughter card gives an extra 2x gbe ports.If this is fitted then install the other 2 switches in bay 3&4.The idea of the switches is to replace the pass thru modules, cut...
View ArticleRe: PE2950 BIOS upgrade without floppy drive
Thanks Rey, I'll give your suggestions a go & will post back the outcome.Once again Thanks for your help guys!
View ArticleRe: Dell Poweredge R210 II not liking Tripplite Ps2 to USB adapter for KVM
accessories.us.dell.com/.../productdetail.aspx
View ArticleErrore - "HWC2005: System board Riser cable or interconnect failure. Check...
Hello all!I bought the new server PowerEge R520. Аs soon as I connected to electricity, on the forward panel, I saw LCD message."HWC2005: System board Riser cable or interconnect failure. Check...
View ArticleRe: Errore - "HWC2005: System board Riser cable or interconnect failure....
Does this server have 1 or 2 processors? Thanks,
View ArticleRe: Errore - "HWC2005: System board Riser cable or interconnect failure....
This server have 1 processor (E5-2407)Information from iDRAC7CPU1 Status Good CPU2 Status Absent
View ArticleRe: Errore - "HWC2005: System board Riser cable or interconnect failure....
If your server has this riser:DXX7K Riser 1- X16 Slot (Used in 2P Config). Then it will throw the error, since its looking for the 2nd CPU. . Will your server go past the error and run? Regards,
View ArticleRe: Errore - "HWC2005: System board Riser cable or interconnect failure....
It is strange. As soon as I cleaned the log through iDRAC7 and rebooted server, the mistake was gone.
View ArticleRe: Errore - "HWC2005: System board Riser cable or interconnect failure....
Thank you very much Geoff P. I like DELL servers! :)
View ArticleRe: Upgrade Hard Drives from 250gb to 2tb on a Poweredge 1800
I have the same issue but I have 3 250Gb drives and a raid 5. Can someone tell me if I can replace the old drives with 3 new 1Tb drives? I figured going with 1Tb drives was more likely compatible and...
View ArticleRe: Dell Poweredge R210 II not liking Tripplite Ps2 to USB adapter for KVM
ok, I have one of those adapters in hand, what I dont have is a a triplite kvm. I have dell 2161DS, and I will give that a shot to see how it behaves.
View ArticleRe: Upgrade Hard Drives from 250gb to 2tb on a Poweredge 1800
same model system and raid card or which models do you have?
View ArticleRe: Dell Poweredge R210 II not liking Tripplite Ps2 to USB adapter for KVM
ok, so here is what I have, Avocent PS/2 sip, connected to the Triplite PS2 to usb adapter, which then connects to the USB port on the R210ii. The video goes straight from the system to the Avocent...
View ArticleRe: Upgrade Hard Drives from 250gb to 2tb on a Poweredge 1800
Poweredge 1800, windows server 2003, Dell Cerc Sata 1.5/6ch Raid Controller, LSI Logic 1020/1030 Ultra 320 SCSI adapter. Under the drives it says Dell Array SCSI Disk Device. I've looked at the...
View ArticleRe: Dell Poweredge R210 II not liking Tripplite Ps2 to USB adapter for KVM
did some checking on mine, heres the part number for my cable U219-000-R, this is a tripplite part number.the setup is basically what i have here, minus the difference in the kvm equipmenttripplite kvm...
View ArticleiDRAC7 virtual console - connection error. will not open
hi allsorry, but i haven't had this issue before - my team mate has given me his r720 to reimage with ESXi5.1 - no worries, but when i log into the iDRAC7 and go to launch virtual console, the...
View ArticleRe: iDRAC7 virtual console - connection error. will not open
Hi, Which plugin are you using? You can check this from "Server -> Console" page. Check Plugin Type. If it is "Native" you need to make sure to configure Internet Explorer to allow Activex...
View ArticleDell PowerEdge 2850 vs Hp MSA 500G2
Hi all!It´s my very first time in this forum, and a newbie with this kind of servers...I Have various Dell PowerEdge 2850 with a extra LSI Logic pcbx 518-B1 SCSI card and I have also an HP MSA 500 G2...
View Article