Quantcast
Channel: PowerEdge General HW Forum - Recent Threads
Viewing all articles
Browse latest Browse all 5911

Re: Blinking cursor when booting a poweredge 1850

$
0
0

Thanks for response.  I looked at documentation and the error was due to "No memory modules installed in the first memory module connector". So when I fixed that issue, I booted up again and now it gets to this part:

"Amount of available memory is limited to 256 mb" Strike the F1 key to continue, F2 to run setup utility.

And then it just gives me a blinking cursor and that's it.

Does this mean it could still be a PCI card issue? Or is this most likely bad RAM issue?


Viewing all articles
Browse latest Browse all 5911

Trending Articles